I've run into scanning problems which are usually solved by unplugging the unit unit power cord and plugging it in again, or by turning off the unit with the power button. However, now, when power is restored, I get a message, "align page," as if I had installed a new cartridge. I can't figure out any way to bypass that message. Then after feeding the alignment page through the feeder (correctly), I get a message "alignment page not detected." Powering down using the power button, pulling the power cord and reinserting is, and pulling the power and USB cord both and reinserting them -- none of these help. Nothing can be done with the printer due to being blocked by the "align page" requirement.
↧